802.1x Authentication on Debian

Datetime:2016-08-23 01:52:33          Topic: Debian           Share

I recently had to setup some Linux workstations with 802.1x authentication (described as “Ethernet authentication”) to connect to a smart switch. The most useful web site I found was the Ubuntu help site about 802.1x Authentication [1] . But it didn’t describe exactly what I needed so I’m writing a more concise explanation.

The first thing to note is that the authentication mechanism works the same way as 802.11 wireless authentication, so it’s a good idea to have the wpasupplicant package installed on all laptops just in case you need to connect to such a network.

The first step is to create a wpa_supplicant config file, I named mine /etc/wpa_supplicant_SITE.conf . The file needs contents like the following:

network={
 key_mgmt=IEEE8021X
 eap=PEAP
 identity="USERNAME"
 anonymous_identity="USERNAME"
 password="PASS"
 phase1="auth=MD5"
 phase2="auth=CHAP password=PASS"
 eapol_flags=0
}

The first difference between what I use and the Ubuntu example is that I’m using “ eap=PEAP “, that is an issue of the way the network is configured, whoever runs your switch can tell you the correct settings for that. The next difference is that I’m using “ auth=CHAP ” and the Ubuntu example has “ auth=PAP “. The difference between those protocols is that CHAP has a challenge-response and PAP just has the password sent (maybe encrypted) over the network. If whoever runs the network says that they “don’t store unhashed passwords” or makes any similar claim then they are almost certainly using CHAP.

Change USERNAME and PASS to your user name and password.

wpa_supplicant -c /etc/wpa_supplicant_SITE.conf -D wired -i eth0

The above command can be used to test the operation of wpa_supplicant.

Successfully initialized wpa_supplicant
eth0: Associated with 00:01:02:03:04:05
eth0: CTRL-EVENT-EAP-STARTED EAP authentication started
eth0: CTRL-EVENT-EAP-PROPOSED-METHOD vendor=0 method=25
TLS: Unsupported Phase2 EAP method 'CHAP'
eth0: CTRL-EVENT-EAP-METHOD EAP vendor 0 method 25 (PEAP) selected
eth0: CTRL-EVENT-EAP-PEER-CERT depth=0 subject=''
eth0: CTRL-EVENT-EAP-PEER-CERT depth=0 subject=''
EAP-MSCHAPV2: Authentication succeeded
EAP-TLV: TLV Result - Success - EAP-TLV/Phase2 Completed
eth0: CTRL-EVENT-EAP-SUCCESS EAP authentication completed successfully
eth0: CTRL-EVENT-CONNECTED - Connection to 00:01:02:03:04:05 completed [id=0 id_str=]

Above is the output of a successful test with wpa_supplicant. I replaced the MAC of the switch with 00:01:02:03:04:05. Strangely it doesn’t like “CHAP” but is automatically selecting “MSCHAPV2” and working, maybe anything other than “PAP” would do.

auto eth0
iface eth0 inet dhcp
  wpa-driver wired
  wpa-conf /etc/wpa_supplicant_SITE.conf

Above is a snippet of /etc/network/interfaces that works with this configuration.





About List